How is a flipper tooth actually made
Share
A flipper tooth is built from a mold of your own mouth, not a dentist visit. A kit reaches your door, you take the impression at home, and a lab technician turns it into a finished appliance in Hollywood, Florida.
The process is the same regardless of which material you choose, only the base itself and the price change.
Step one, the impression kit
The kit includes two sets of trays and putty, so there is a backup if the first attempt goes wrong. A short video walks through seating the tray and holding still while the putty sets.
Most people finish both impressions in under 20 minutes at their own kitchen table.
Step two, technician review
Every impression is checked before anything is built. Air bubbles, short pulls or a tray that did not seat fully get caught here, and a failed attempt gets a fresh kit mailed out at no charge.
Close-up photos of your smile go in the same package, and those are what a technician matches the tooth shade against.
Step three, the build itself
Material choice changes the price, not the process
| Material | Price | Clasp |
|---|---|---|
| Acrylic | $319 | Thin wire |
| Semi-flex | $349 | None, milled |
| Flexible | $399 | None, thermoplastic |
Home impression kit and free shipping both ways are inside every price.
Acrylic is molded and finished with a thin wire clasp. Semi-flex is milled from a single block for a firmer, metal-free fit. Flexible is injected in a thermoplastic that bends slightly and needs no clasp at all.
Step four, it ships to you
The finished appliance ships 14 to 28 days after your impressions are accepted, and a fitted case comes with it for storage. Take it out at night so your gum gets air.
If anything about the fit feels off, contact us before adjusting it yourself, since the warranty covers the build only if it has not been altered.
Questions people actually ask
Do I need to visit a dentist to get a flipper tooth
No. The whole process runs through a home impression kit, and a technician reviews everything before it is built.
What happens if the impression is not good enough
A technician catches it during review and ships a fresh kit at no charge, so a bad mold never turns into a bad flipper.
How long does the whole process take
The kit reaches you by USPS in 3 days or FedEx overnight, and the finished flipper arrives 14 to 28 days after your impressions are accepted.
Where is it actually made
In an independent dental lab in Hollywood, Florida, by the same technicians who review your impressions in the first place.
Is there a warranty on the finished piece
Yes, a 60 day manufacturer warranty covers the build, and adjustments during that window are on us.
Deciding which material fits your case, read how much a flexible flipper costs. Comparing it against a bigger appliance, see the flipper and partial denture comparison.